Siemens SINUMERIK 840DE Operation & Programming Manual page 176

11
Alarms and Messages
11.2 Alarms with ManualTurn
111 007
Explanation
Reaction
Remedy
111 008
Explanation
Reaction
Remedy
111 009
Explanation
Reaction
Remedy
111 010
Explanation
Reaction
Remedy
111 100
Explanation
Reaction
Remedy
111 105
Explanation
Reaction
Remedy
11-176
Error in line %1 %2
%1 = Line number
%2 = Description of error
Alarm display
NC start disable
Remove the error.
Spindle not synchronized
Spindle not synchronized
Alarm display
Allow spindle to turn for at least one revolution (M3, M4).
Insert new tool: T%1
T%1 = Tool number
Tool change program requests a new tool
Alarm display
NC Stop
Insert new tool
Teach In Cancellation: Log overflow
Teach in procedure canceled.
Alarm display
Teach in file closed.
The refresh rate must be increased by 100 to 200 ms in MD 9606:
$MM_CTM_SIMULATION_TIME_NEW_POS.
Wrong position programmed for spindle
A position outside the range 0 - 359.999 has been programmed for a
modulo axis.
Alarm display
Interface signals are set
Interpreter stop
NC start disable
Program position in the range 0 - 359.999.
Reset alarm with RESET key. Restart program.
No measuring system exists
SPCON, SPOS or SPOSA has been programmed. These functions
require at least one measuring system. According to MD: NUM_ENCS
the machine axis/spindle has no measuring system.
Alarm display
Interface signals are set
Interpreter stop
NC start disable
Add a measuring system.
Reset alarm with RESET key. Restart program.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
11
08.02