Siemens SINUMERIK 840DE Operation & Programming Manual page 65

4
08.02
Conical
Positioning
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
Select the desired axis direction.
X Facing
Z Longitudinal turning
b) Taper turning
Select the soft key labeled "Conical".
Select reference direction Z.
Enter angle and confirm your selections by pressing the "Input" key.
α
e.g. 4°
Enter tool number of tool currently in use.
Enter feed mode and speed and confirm your settings by pressing the
"Input" key.
e.g. F 0.3 mm/rev
S 320 rev/min
Feed movement with
• Press Start key
• Press Stop key
• You can interrupt the feed motion at any time by pressing the Stop
key or turning the control stick back to the center position.
• If manual mode is active you can also traverse the axes using the
handwheels. However, if you move the transverse axis using the
handwheel, the travel path generated by the handwheel is not
included in the constant cutting speed.
c) Positioning
Select the soft key labeled "Positioning".
Select the axis to be traversed and enter the target position.
Enter the desired value for feed F, for example, 1000 mm/min.
The selected feed is only effective for positioning and not for the
elements straight or conical.
Turning Simple Contours
4.1 Turning in manual mode
4
4-65