9
08.02
9.2.4 Transferring machining steps to system
Fast adjustment of the slide
Manual movements in the
transverse and longitudinal
directions
Teach rapid
traverse
Teach
feedrate
No
Teach
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
In general, all programmed motions that are executed with "NC start"
in modes STRAIGHT, CONICAL, CIRCLE, CONTOUR, CYCLE,
STOCK REMOVAL and PROGRAM are automatically stored.
Programmed spindle speed values and feedrates are multiplied by the
percentage of the override switch in question at the end of a
movement and transferred to the EasyStep program.
In manually performed movements a distinction is made between:
•
Fast adjustment of the slide
•
Manual movements in the transverse and longitudinal directions
•
Slide movements in MANUAL mode using the control stick
using the control stick and the rapid traverse key.
Additional notes
The program step is automatically stored in PROGRAM mode if the
relevant machine data has been set. Please follow the advice of the
machine manufacturer.
When you have performed the manual movements press the "NC
Start" key.
The following three soft keys appear in the soft key menu:
Store movement as rapid traverse.
Store movement as feedrate.
The feedrate is stored in a machine data. Please follow the advice of
the machine manufacturer.
Do not store movement.
9
General Functions
9.2 Teach In
9-163