7
08.02
7.2
Creating a machining sequence
New
program
END
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
7.2 Creating a machining sequence
Sequence of operations
Select PROGRAM mode.
Press the soft key labeled "New program".
Enter a name for the machining sequence and confirm. The name
must not contain more than 24 characters. All letters (excluding
accented characters, such as German umlauts), figures, and the
underscore (_) are allowed.
The machining sequence is stored in the Program directory.
Switch to the operating mode in which you want to start your new
machining operation. Insert the required program step into the
machining sequence. Repeat this procedure for further program steps.
The individual program steps are inserted into the program via
"Accept".
When a new EasyStep program is created, the machining symbol
"END" is automatically inserted in the end of program step in the
machining sequence.
Program Creation with EasyStep and G Code
7
7-131