5
08.02
X1
R
N
α α α α 0
α α α α 1
Z0
Z1
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
5.2 Turning cycles in CYCLE mode
Drilling depth (inc) or end diameter (abs) where the final drilling depth
is.
Face end
Radius of hole circle
For drilling behind the turning center, you must enter a negative
parameter value.
Number of holes
Base rotation angle
(see peripheral end)
Advance angle
(see peripheral end)
Reference point
Final drilling depth.
For setting the parameters for the deep hole drilling cycle/thread
drilling cycle contained in the hole circle cycle, please proceed as
described in section "Drilling in the longitudinal axis (center)".
5
Turning with Cycles
5-99