Chapter 8 Various Settings; Adding A Module - Mitsubishi Electric MELSEC-Q series User Manual

CHAPTER 8
This chapter describes the setting procedures of the CT input module.
● After writing the contents of the new module, parameter settings, and auto refresh settings into the CPU module, reset
the CPU module and switch its status as STOP  RUN  STOP  RUN, or turn off and on the power supply to activate
the settings.
● After writing the contents of the switch settings, reset the CPU module or turn off and on the power supply to activate the
settings.
8.1

Adding a Module

Add the model name of the CT input module to use on the project.
(1) Addition procedure
Open the "New Module" window.
Project window
Module Selection
Mount Position
Title Setting
142
VARIOUS SETTINGS
[Intelligent Function Module]
Item
Module Type Set [Analog Module].
Module Name Set the name of the module to mount.
Base No. Set the base No. where the module is mounted.
Mounted Slot No. Set the slot No. where the module is mounted.
Specify start XY The start I/O number (hexadecimal) of the target module is set, according to
address the mounted slot No. Any start I/O number can be set.
Title Set any title.
Right-click [New Module...]
Description