Error code
Description and the error cause
(decimal)
The set logging cycle is shorter than the update cycle of the
*1
logged value (digital output value or scaling value).
202
The channel where the error has occurred fits in .
CH Logging data setting (Un\G1024 to Un\G1031) is set to a
*1
value other than 0 and 1.
203
The channel where the error has occurred fits in .
CH Logging points after trigger (Un\G1048 to Un\G1055) is
*1
set to a value outside the range of 1 to 5000.
204
The channel where the error has occurred fits in .
CH Level trigger condition setting (Un\G1056 to Un\G1063) is
*1
set to a value outside the range of 0 to 3.
205
The channel where the error has occurred fits in .
CH Trigger data (Un\G1064 to Un\G1071) is set to a value
*1
outside the range of 0 to 4999.
206
The channel where the error has occurred fits in .
CH Logging hold request (Un\G1008 to Un\G1015) is set to a
*1
value other than 0 and 1.
207
The channel where the error has occurred fits in .
*1
These error codes can be cleared by turning on then off Error clear request (YF).
*2
This error code is not stored in Latest error code (Un\G19) but in the completion status of the G(P).OGSTOR instruction
(
+ 1).
S
CHAPTER 11 TROUBLESHOOTING
Action
Set CH Logging cycle setting value (Un\G1032 to
Un\G1039) and CH Logging cycle unit setting
(Un\G1040 to Un\G1047) so that the logging cycle is
equal to or longer than the update cycle of the logged
value.
For the setting procedure of a logging cycle, refer to
the following.
(
• Logging Function
Page 58, Section 4.12)
Set Digital output value (0) or Scaling value (1) in
CH Logging data setting (Un\G1024 to Un\G1031).
Set a value within the range of 1 to 5000 in CH
Logging points after trigger (Un\G1048 to Un\G1055).
Set one of the following values in CH Level trigger
condition setting (Un\G1056 to Un\G1063).
• Disable (0)
• Above (1)
• Below (2)
• Pass through (3)
Set a value within the range of 0 to 4999 in CH
Trigger data (Un\G1064 to Un\G1071).
Set OFF (0) or ON (1) in CH Logging hold request
(Un\G1008 to Un\G1015).
11
227