Mitsubishi Electric MELSEC-Q series User Manual page 131

(40)CH Trigger data (Un\G1064 to Un\G1071)
Set a buffer memory address monitored for the occurrence condition of level trigger.
For details on the logging function, refer to the following.
• Logging Function (
(a) Setting range
• Setting range: 0 to 4999
• In the channel where a setting value other than the above is set, an error occurs. The error code (206) is
stored in Latest error code (Un\G19) and Error flag (XF) turns on. Also, logging cannot be performed.
Set the following buffer memory addresses in the trigger data.
• CH Digital output value (Un\G11 to Un\G18): 11 to 18
• CH Scaling value (Un\G54 to Un\G61): 54 to 61
• Level data  (Un\G1072 to Un\G1081): 1072 to 1081
• Buffer memory address with "R" in List of Buffer Memory Addresses
For details on the buffer memory address, refer to the following.
List of Buffer Memory Addresses (
Do not set the buffer memory addresses with "R/W" or "W" or system area in List of Buffer Memory Addresses. If they are
set, the normal operation of the CT input module may not be ensured.
(b) Enabling the setting
Turn on then off Operating condition setting request (Y9) to enable the setting.
(c) Default value
Channel
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
Page 58, Section 4.12)
Page 89, Section 6.1)
Default value
54 CH1 Scaling value (Un\G54)
55 CH2 Scaling value (Un\G55)
56 CH3 Scaling value (Un\G56)
57 CH4 Scaling value (Un\G57)
58 CH5 Scaling value (Un\G58)
59 CH6 Scaling value (Un\G59)
60 CH7 Scaling value (Un\G60)
61 CH8 Scaling value (Un\G61)
CHAPTER 6 BUFFER MEMORY
Buffer memory to be monitored
6
129