Panasonic KX-TVM50 Programming Manual page 118

2.5 System Parameters
Forward to Other Extension
Specifies the DTMF signal used to indicate a Forward to Other Extension tone. Sent to the VPS when
the dialled extension has set calls to be forwarded to another extension.
Value Range
Max. 16 digits consisting of 0–9,
Confirmation
Specifies the DTMF signal used to indicate a confirmation tone. Sent to the VPS when the Message
Waiting Lamp was successfully turned on or off.
Value Range
Max. 16 digits consisting of 0–9,
Disconnect
Specifies the DTMF signal used to indicate a disconnect tone. Sent to the VPS when the other party
goes on-hook.
Value Range
Max. 16 digits consisting of 0–9,
Digit Translation Table
Use the Digit Translation Table to translate Follow On ID Signals received from the PBX into the codes
needed by the VPS. This translation table is only effective for incoming signals. Settings made here
should correspond to the Follow On ID settings of the PBX.
Inter-Digit Timeout
Defines the maximum length between the digits of a Follow On ID signal. If this time expires, the VPS
will stop detecting Follow On ID for the call.
Value Range
1 s–4 s
Translation Table (Table 1–Table 8)
Follow the steps below to edit the Translation Table
1.
Click Click to edit....
2.
Enter the digits sent from the PBX under "Input Digit" and the corresponding digits received by
the VPS under "Output Digit" in the Translation Table dialogue box.
3.
Click OK.
Input/Output digit
Defines the input and output digits that are translated by the Digit Translation Table. Do not assign the
same sequence of Input digits more than once; if this occurs, the VPS will use the first assignment.
118 Programming Manual
, #, and A–D
, #, and A–D
, #, and A–D