Panasonic KX-TVM50 Programming Manual page 45

Device Notification for Unreceived Message
If set to "Yes", the VPS calls the appropriate device beginning with the lowest numbered device
programmed for the mailbox, until unplayed messages are received.
Value Range
No, Yes
Feature Manual References
2.2.31 Message Waiting Notification—Device
Notification Schedule
Specifies the Message Waiting Notification schedule for each device. The following parameters can
be specified per device.
Follow the steps below to edit Notification Schedule:
1.
Click Click to edit....
2.
Select a device (Device No. 1, Device No. 2, Device No. 3) tab.
3.
Edit parameters.
4.
Click OK.
Notification Type
Specifies the type of message for which notification is sent. Notification can be sent for all messages,
or urgent messages only.
Value Range
All Messages, Only Urgent Messages
Feature Manual References
2.2.31 Message Waiting Notification—Device
Dial Number
Assigns a telephone or beeper (pager) number to Device 1, 2, or 3. The subscriber can also specify
the number to be dialled by entering it from his or her telephone, allowing the subscriber to set this
feature on a case by case basis.
Note
• The callback number entry code "X" must be included in the number to be called if the
"Beeper Callback No. Entry Mode" is set to any values other than "Disable" (see"Beeper
(Pager) Callback No. Entry Mode") and "Type of Device" is set to "Beeper". The proper "Dial
Pauses" must be inserted before the callback entry code.
• When the VPS calls a Trunk via a PRI (ISDN Primary Rate Access Interface) card of a
Panasonic PBX, please be sure to add "#" after the telephone number (1112223333 in the
example here):
Example: 9P1112223333#PP123PP456PPX# (P: Dial Pause)
Value Range
Max. 32 digits consisting of 0–9, , # and special codes:
2.1 Mailbox Settings
Programming Manual 45