Panasonic KX-TVM50 Programming Manual page 125

Release for Intercom Paging
Specifies the intercom paging release sequence. The settings made here must match the settings of
the PBX. The sequence can be a combination of 7 letters and 12 dial codes.
Value Range
Max. 16 digits consisting of 0–9,
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause for 1 s (default)
;: Dial Pause for 3 s (default)
X: Pager Dialling
0–9, , #: Dial Codes
Feature Manual References
2.2.25 Intercom Paging (APT/DPT Integration Only)
No Answer Time for Intercom Paging
Specifies the length of time (in seconds) the VPS waits before concluding Intercom Paging when
there is no answer. The VPS will return to the caller if the paged party does not respond before this
timer expires.
Value Range
1 s–30 s
Feature Manual References
2.2.25 Intercom Paging (APT/DPT Integration Only)
Announcement Repeat Cycle
Specifies the number of times the VPS announces the page.
Example:
"I have a call for (subscriber's name)".
Value Range
1–3 times
Feature Manual References
2.2.25 Intercom Paging (APT/DPT Integration Only)
Intercom Paging Retry
Specifies the number of times to retry paging when the called subscriber has set Incomplete Call
Handling to "Intercom Paging" and the subscriber is busy or if there is no answer.
, # and special codes
2.5 System Parameters
Programming Manual 125