Panasonic KX-TVM50 Programming Manual page 121

Message Waiting Lamp Ports
Specifies the port numbers used for Message Waiting Notification Lamp feature. The VPS turns on
the Message Waiting Lamp of the extension using the port specified in this parameter. At least 1 port
must be specified.
Note
• The maximum number of ports depends on the VPS model.
Value Range
1–6 (KX-TVM50), 1–24 (KX-TVM200/KX-NCV200)
Feature Manual References
2.2.32 Message Waiting Notification—Lamp
Message Waiting Lamp for Every Message
If set to "Yes", the VPS will turn on the Message Waiting Lamp of the extension each time a new
message is recorded in the mailbox. This will occur even if the Message Waiting Lamp was not turned
off from a previous message. This setting is useful when the first attempt is unsuccessful. If set to
"No", the VPS will turn on the Message Waiting Lamp for the first message only. The VPS will not turn
on the lamp for subsequent messages until the subscriber has accessed the VPS to retrieve the
messages stored there.
Value Range
No, Yes
Feature Manual References
2.2.32 Message Waiting Notification—Lamp
Max. Digits for Callback No.
Specifies the maximum number of digits the caller can enter as a callback number. This callback
number will be displayed on beepers if "Beeper Callback No. Entry Mode" set to any values other than
"Disable" (see "Beeper (Pager) Callback No. Entry Mode" in 2.1.4 Notification Parameters).
Value Range
1–48 digits
Feature Manual References
2.2.31 Message Waiting Notification—Device
Callback No. Entry Interdigit Time-out
Specifies the length of time the VPS will wait for the caller to press another dial key during Beeper
Callback No. Entry. If the caller does not enter any digits within the specified time, the VPS will accept
the digits already dialled by the caller as the Beeper Callback Number, then announce the dialled
digits to the caller for confirmation.
Value Range
1 s–10 s
2.5 System Parameters
Programming Manual 121