Hitachi IJ PH Service Manual page 39

4 The measurement is completed in four minutes, and a coefficient
(calculated value) will be displayed
If the process status is "fault" and message "Check viscometer for any defect" appears,
Normal measurement has not been executed . Follow "4.9 Troubleshooting when fault
occurs in viscometer".
5 Press OK
If the OK key is pressed when the process status is "normal end", the coefficient will be
registered, and the circulation control screen will be displayed.
[Note at the calibration]
- The coefficient will not be registered when Cancel is pressed instead of OK key.
Status:XXXXXX
2-21