4 Remove the fixing screws (6 pieces) of the hinges(2 positions)
and then remove the controller part from the body.
Hinges
(2 potions)
5Remove the 3 connectors (CN2、CN4、CN8) on EZJ124 board
and the touch panel connection cable. And then remove the fixing screws
(5 pieces) of EZJ124 board and remove EZJ124 board.
LCD
(Backside of panel)
Fixing screws
(5 pieces)
Fixing screws
(6 pieces)
Touch panel
EZJ124 board
connection cable
EZJ97 board
Caution
!
When inserting the touch panel connection cable
into the connector on EZJ102 board, always hold
both sides of reinforced section for connection (as
shown in the figure) so that the cable is not bent.
3-10
Controller part
Battery
Connector for
LCD (CN8)
Connector for
EZJ97 board
(CN4)
Battery connection
cable(CN2)