Operating sequence
1. The following ways of establishing a "network connection" are available:
– Select "Connection" in the main window menu.
– Press the "Connection"
– Select "Connection" > "Connect..." in the main window menu.
2. Press the "Connect" button in the selection dialog.
3. If a selection dialog containing only the direct connection opens when you press the
"Connect" button in the toolbar, this means you have not yet parameterized any network
connections. Parameters have to be assigned to them in advance. Proceed as described
in Section Assigning parameters for network connection (Page 27).
4. If you have not entered any authentication data, a dialog for entering the authentication
data opens.
SINUMERIK Integrate Access MyMachine /P2P (PC)
Operating Manual, 11/2016, A5E39356962B AA
The last five network connections are offered for selection.
Select one of the menu entries.
The connection to the selected control is established.
- OR -
- OR -
A selection dialog opens, in which you still have to select the corresponding connection.
All the saved connections are available for selection here.
Figure 5-6
Select connection...
button in the toolbar.
Connection to the control
5.3 Establishing the connection
33