Connecting Amm To The Control System Via The Modem Connection - Siemens SINUMERIK 840D sl Operating Manual

Figure 5-43
A connection is established to the TS adapter.
5.5.10

Connecting AMM to the control system via the modem connection

Operating sequence
1. Establish a modem connection (Page 67) to your TS adapter.
2. Next, start AMM and select the direct connection (see Establishing the connection
(Page 31)). Enter the authentication data you wish to use when logging onto the control
system. This is not the same data you entered for the TS adapter.
3. Once you have established the connection, you can copy files in either direction and operate
the control system remotely.
Note
When making the settings for the connection used (direct connection or network
connection) in AMM, you should set the "Transmission type" to transmission rate "Low". If
you do not do this, you may not be able to operate the control remotely, and the connection
may suffer from frequent interruptions.
This setting only applies to remote control: it does not apply to file transfers.
See also
Establishing the connection (Page 31)
Establish modem connection under Windows 7 (Page 67)
SINUMERIK Integrate Access MyMachine /P2P (PC)
Operating Manual, 11/2016, A5E39356962B AA
Dial up - establish connection
Connection to the control
5.5 Establishing a modem connection
75