Establishing A Connection/Cabling - Siemens SINUMERIK 840D sl Operating Manual

Connection to the control
5.5 Establishing a modem connection
5. Enter IP parameter as described as from Assigning parameters for the TS Adapter
(Page 43) Step 4.
6. Continue through the following steps:
– see Administrating the TS Adapter (Page 45)
– see Assigning parameters for the internal modem (Page 52)
– see Establishing a connection/Cabling (Page 60)right through to Connecting AMM to
See also
Create modem connection under Windows 7 (Page 62)
Establish modem connection under Windows 7 (Page 67)
Assigning parameters for the TS Adapter (Page 43)
Administrating the TS Adapter (Page 45)
Assigning parameters for the internal modem (Page 52)
Establishing a connection/Cabling (Page 60)
Connecting AMM to the control system via the modem connection (Page 75)
5.5.5

Establishing a connection/Cabling

Components
You will need the following components:
● Two modem terminals in the general telephone network for the following components:
– PC
– TeleService adapter IE
● PC with 56k modem
● TeleService adapter IE
● Ethernet cable
● Control system (840D sl with NCU 720.1 in this example)
Requirement
You need to have assigned parameters (Page 38) for the TeleService adapter IE.
60
the control system via the modem connection (Page 75)
SINUMERIK Integrate Access MyMachine /P2P (PC)
Operating Manual, 11/2016, A5E39356962B AA