Setting Up The Pg/Pc Interface - Siemens SINUMERIK 840D sl Operating Manual

See also
Setting up the PG/PC interface (Page 37)
Establishing a connection/Cabling (Page 60)
Parameterize the TeleService adapter IE with the "TeleService" software (Page 38)
Parameterize the TeleService adapter IE without the "TeleService" software (Page 59)
5.5.2

Setting up the PG/PC interface

Operating sequence
During the installation of the "TeleService" software you are prompted to set up the PG/PC
interface
.
1. Check the dialog box "Set up PG/PC interface".
– If the "TS Adapter IE" interface is included in the selection list, go to
– If the "TS Adapter IE" interface is missing from the list, continue with
2. To add or remove interfaces, click
"Select...".
The "Install/Remove Interface" dialog box opens.
3. Select the "TS Adapter IE" module from the selection list and
install the adapter.
4. Click "Close" to close the dialog box.
5. In the "Set up PG/PC interface" dialog box select the TS adapter IE.
6. Click "Properties".
The "Properties - TS Adapter IE" dialog box opens.
7. Open the "Local Modem" tab.
8. Under "Modem:" select the modem with which you want to connect to the TS adapter IE.
Under ISDN select the protocol "B-Kanal-Protokoll X.75",
e.g. "AVM ISDN SoftCompensation X.75-V.42bis"
SINUMERIK Integrate Access MyMachine /P2P (PC)
Operating Manual, 11/2016, A5E39356962B AA
step 5.
step 2.
Connection to the control
5.5 Establishing a modem connection
37