Establishing A Modem Connection; General Information - Siemens SINUMERIK 840D sl Operating Manual

Connection to the control

5.5 Establishing a modem connection

5.5 Establishing a modem connection
5.5.1

General information

There are various ways to set up a modem connection from the PC to the control.
This brief guide describes a modem connection to the 840D sl control using the
TeleService Adapter IE (TS Adapter).
This brief guide describes the following two options for the parameterization:
● TeleService Adapter with the "TeleService" software
● TeleService Adapter without the "TeleService" software
The "TeleService" software is included with the TeleService Adapter. More information about
the software can be found in the Help for the TeleService adapter.
Figure 5-7 Modem connection from the PC to the control via the network and the TeleService Adapter IE
Note
You can only establish (Page 60) the connection/cabling as shown in the figure after you have
assigned parameters (Page 38) for the TeleService Adapter IE with the PC.
36
SINUMERIK Integrate Access MyMachine /P2P (PC)
Operating Manual, 11/2016, A5E39356962B AA