Fault And Alarm Messages; General Information About Faults And Alarms - Siemens SINAMICS S120 Commissioning Manual

Overview of key parameters (see SINAMICS S List Manual)
Adjustable parameters
● p0771[0...2] CI: Measuring sockets signal source
● p0777[0...2] Measuring sockets characteristic value x1
● P0778[0...2] Measuring sockets characteristic value y1
● p0779[0...2] Measuring sockets characteristic value x2
● p0780[0...2] Measuring sockets characteristic value y2
● p0783[0...2] Measuring sockets offset
● p0784[0...2] Measuring sockets limit on/off
Display parameters
● r0772[0...2] Measuring sockets output signal
● r0774[0...2] Measuring sockets output voltage
● r0786[0...2] Measuring sockets normalization per volt
3.3

Fault and alarm messages

3.3.1

General information about faults and alarms

Description
The errors and states detected by the individual components of the drive system are
indicated by messages.
The messages are categorized into faults and alarms.
Note
The individual faults and alarms are described in the SINAMICS S List Manual (LH1) in
Chapter "Faults and Alarms". Function diagrams for the fault buffer, alarm buffer, fault trigger
and fault configuration are also contained in the Section "Function diagrams" -> "Faults and
alarms".
Properties of faults and alarms
● Faults
Commissioning
Commissioning Manual, (IH1), 07/2007 Edition, 6SL3097-2AF00-0BP7
– Are identified by Fxxxxx.
– Can lead to a fault reaction.
Diagnosis
3.3 Fault and alarm messages
139