Siemens SINAMICS S120 Commissioning Manual page 52

Commissioning
2.2 STARTER commissioning tool
● Module -> Load
Note
The IP address and device name for the Control Unit are stored on the CompactFlash
card (non-volatile).
Assignment with STARTER, "Accessible nodes" function
You can use STARTER to assign an IP address and a name to the PROFINET interface
(e.g. CBE20/CU310 PN).
● Connect the direct Ethernet cable from the PG/PC to the PROFINET interface.
● Switch on the Control Unit.
● Open STARTER.
● A search is performed for available nodes in PROFINET via Project -> Accessible nodes
● The SINAMICS drive object with CBE20 is detected and displayed as a bus node with IP
● Mark the bus node entry and select the displayed menu item "Edit Ethernet node" with
● In the following "Edit Ethernet node" screen, enter the device name for the PROFINET
● The "Update (F5)" button displays the IP address and name in the entry for the bus node.
● If the PROFINET interface is displayed as bus node, mark the entry and click the
● The SINAMICS drive with CBE20 is displayed as drive object in the project tree.
● Further configurations can be performed for the drive object.
● Click the "Connect to target system" and load the project to the CompactFlash card of the
Note
The IP address and device name for the Control Unit are stored on the CompactFlash
card (non-volatile).
52
or the "Accessible nodes" button.
address 0.0.0.0 and without name.
the right mouse button.
interface and click the "Assign name" button. Enter the IP address (e.g. 192.168.0.2) in
the IP configuration and specify the subnet screen (e.g. 255.255.255.0). Then click the
"Assign IP configuration" button. Close the screen.
If not, close the "Accessible nodes" screen and perform another search for accessible
nodes.
"Accept" button.
Control Unit with Target system -> Load -> To target device.
Commissioning Manual, (IH1), 07/2007 Edition, 6SL3097-2AF00-0BP7
Commissioning