Commissioning
2.1
Sequence of operations during commissioning
Once the basic requirements have been met, you may proceed as follows to commission the
drive:
Table 2-1
Note
If motors with a DRIVE-CLiQ interface are used, all motor and encoder data should be saved
in a non-volatile manner for spare part usage of the Sensor Module on the motor via
p4692 = 1 (for more information, see Function Manual).
2.1.1
Safety guidelines
A hazardous voltage will be present in all components for a further five minutes after the
system has been shutdown.
Note the information on the component!
A project with Safety Integrated may not be created offline.
Commissioning
Commissioning Manual, (IH1), 07/2007 Edition, 6SL3097-2AF00-0BP7
Commissioning
Step
1
Create project with STARTER.
2
Configure the drive unit in STARTER.
3
Save the project in STARTER.
4
Go online with the target device in STARTER.
5
Load the project to the target device.
6
The motor starts to run.
DANGER
CAUTION
Activity
2
43