Stud; Stud Specifications; Distance Between Studs - Mitsubishi Electric GOT2000 Series User Manual

6.3

Stud

6.3.1

Stud specifications

Use the studs that satisfy the following specifications.
Diameter
M4 10 mm (0.39 inch) or more
The studs on the control panel must have strength adequate to withstand a tightening torque of 0.9 N•m or more.
Make sure that no foreign matter such as welding waste is at and around the bases of the studs.
Tighten nuts on the studs in the specified torque range (0.8 N•m to 0.9 N•m) with a wrench for M4 nuts.
6.3.2

Distance between studs

■1. GT2512F-S, GT2510F-V, GT2508F-V
To mount the GOT on the control panel, studs are necessary.
Align the studs with the installation holes of the fittings, and install the studs.
The fittings must be installed on the top and bottom, or the right and left of the GOT.
For GT2512F, you are recommended to install the fittings on the long sides of the GOT.
(1) Measurements based on the screen center
Horizontal
Y1
Back of the control panel
Model
GT2512F-S
GT2510F-V
GT2508F-V
6 - 8

6.3 Stud

Length
Y
Y2
Screen center
X X1
214(8.43) 103(4.06)
(+2(0.08), 0(0)) (+2(0.08), 0(0))
187(7.36) 89.5(3.52)
(+2(0.08), 0(0)) (+1(0.04), 0(0))
158(6.22) 75.25(2.96)
(+2(0.08), 0(0)) (+1(0.04), 0(0))
Vertical
panel opening
Back of the control panel
X2 Y
269(10.59)
(111(4.37))
(+2(0.08), 0(0))
234(9.21)
(97.5(3.84))
(+2(0.08), 0(0))
194(7.64)
(82.75(3.26))
(+2(0.08), 0(0))
X
X1 X2
Screen center Screen center Screen center
Unit: mm (inch)
Y1
134.5(5.30)
(+1(0.04), 0(0))
117(4.61)
(+1(0.04), 0(0))
97.5(3.84)
(+1(0.04), 0(0))
Y2
(134.5(5.30))
(117(4.61))
(96.5(3.80))