Processors And Heat Sinks; Removing A Processor And Heat Sink Module - Dell EMC PowerEdge R940 Installation And Service Manual

NOTE: The memory module socket has an alignment key that enables you to install the memory module in the socket in
only one orientation.
4 Press the memory module with your thumbs until the socket levers firmly click into place.
Figure 54. Installing a memory module
Next steps
1 If applicable, install the air shroud.
2 Follow the procedure listed in
3 To verify if the memory module has been installed properly, press F2 and navigate to System Setup Main Menu > System BIOS >
Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of the installed
memory.
4 If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module is firmly
seated in the memory module socket.
5 Run the system memory test in system diagnostics.
Related links
Installing the air shroud

Processors and heat sinks

The processor controls memory, peripheral interfaces, and other components of the system. The system can have more than one
processor configurations.
The heat sink absorbs the heat generated by the processor, and helps the processor to maintain its optimal temperature level.

Removing a processor and heat sink module

Prerequisites
WARNING: The heat sink may be hot to touch for some time after the system has been powered down. Allow the heat sink to
cool before removing it.
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
After working inside your system.
Safety instructions.
Before working inside your system.
Installing and removing system components 101