Installing The Ndc Riser - Dell EMC PowerEdge R940 Installation And Service Manual

Installing the NDC riser

Prerequisites
Follow the safety guidelines listed in
Steps
1 Hold the Network Daughter Card (NDC) riser by its edges and align the connector on the NDC riser with the connector on the system
board.
2 Insert the NDC riser until the card is fully seated.
3 Close the riser retention bracket and slide the bracket to lock the NDC riser.
Figure 79. Install the NDC riser
Next steps
1 Connect the cables to the NDC riser.
2 Follow the procedure listed in
126 Installing and removing system components
Safety instructions.
After working inside your system.