Installing The Optional Idsdm/Vflash Card - Dell EMC PowerEdge R940 Installation And Service Manual

NOTE: Temporarily label each micro SD card with its corresponding slot number after removal.
Steps
1 Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash, see the System board jumpers and connectors section.
2 Holding the pull tab, lift the IDSDM/vFlash card out of the system.
Figure 84. Removing the optional IDSDM/vFlash card
Next steps
Install the optional IDSDM/vFlash card.
Related links

Installing the optional IDSDM/vFlash card

Installing the optional IDSDM/vFlash card
Prerequisites
Follow the safety guidelines listed in
Steps
1 Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash, see the System board jumpers and connectors section.
2 Align IDSDM/vFlash card with the connector on the system board.
3 Push IDSDM/vFlash card until it is firmly seated on the system board.
132 Installing and removing system components
Safety instructions.