Dell EMC PowerEdge R940 Installation And Service Manual page 143

Figure 93. Installing system board
Next steps
1 Install the Trusted Platform Module (TPM).
NOTE: The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM plug-in
module will be provided for all system board replacements where a TPM plug-in module was installed.
2 Replace the following:
a Cable management bracket
b Integrated storage controller card
c Internal USB key (if applicable)
d iDSDM/vFlash card
e Processor expansion module (PEM)
f Expansion card risers
g Processor and heat sink module
h Processor and DIMM blank
i Memory modules and memory module blanks
j Network daughter card
k Fan cage with cooling fans
l Air shroud
m Power supply unit(s)
3 Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
4 Follow the procedure listed in
5 Import your new or existing iDRAC Enterprise license. For more information, see Integrated Dell Remote Access Controller User's
Guide, at Dell.com/esmmanuals.
After working inside your system.
Installing and removing system components 143