Removing The Left Control Panel - Dell EMC PowerEdge R940 Installation And Service Manual

Next steps
1 Lift the sides of the fan tray until the blue release tabs click in place.
2 If applicable, install the expansion card risers and PEM.
3 Install the air shroud.
4 Install the fan cage.
Related links
Installing the PEM
Installing the expansion card riser
Installing the air shroud
Installing the fan tray
Installing the fan cage

Removing the left control panel

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the fan cage.
4 Remove the air shroud.
5 If applicable, remove the expansion card risers and PEM.
NOTE: Ensure that you note the routing of the cables as you remove them from the system. You must route the cables
properly when you replace them to prevent the cables from being pinched or crimped.
6 Press the blue release tabs on the fan tray and lower the sides of the tray.
Steps
1 Holding the pull tab, disconnect the control panel cable from the connector on the system board.
2 Using Phillips #1 screwdriver, remove the screws that secure the left control panel to the system.
3 Holding the control panel by its sides, remove the control panel away from the system.
Safety instructions.
Before working inside your system.
Installing and removing system components 149