Input Cable Fuses - ABB ACS800 Hardware Manual

Input cable fuses

The ratings of UL listed fuses for branch circuit protection are listed below. The fuses
also prevent damage to the adjoining equipment of the drive in case of a short-circuit
inside the drive. Check that the operating time of the fuse is below 0.1 seconds.
The operating time depends on the supply network impedance and the cross-
sectional area and length of the supply cable. The fuses must be of the "non-time
delay" type. See also Planning the electrical installation:
short-circuit
Note 1: In multicable installations, install only one fuse per phase (not one fuse per conductor).
Note 2: Larger fuses must not be used.
Note 3: Fuses from other manufacturers can be used if they meet the ratings.
ACS800-U31 type
ACS800-31 type
Three-phase supply voltage 208 V, 220 V, 230 V or 240 V
-0011-2
-0016-2
-0020-2
-0025-2
-0030-2
-0040-2
-0050-2
-0060-2
Three-phase supply voltage 380 V, 400 V, 415 V, 440 V, 460 V, 480 V or 500 V
-0020-5
-0025-5
-0030-5
-0040-5
-0050-5
-0060-5
-0070-5
-0100-5
-0120-5
Three-phase supply voltage 525 V, 575 V, 600 V
-0060-7
-0070-7
-0100-7
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
protection.
Input
current
A A
32 40
44 70
55 80
70 90
82 100
112 150
140 200
157 200
29 40
33 50
44 70
54 80
65 90
76 100
112 150
129 200
145 200
53 80
73 100
86 125
Thermal overload and
Fuse
V Manufacturer
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
600 Bussmann
107
Type UL class
JJS-40 T
JJS-70 T
JJS-80 T
JJS-90 T
JJS-100 T
JJS-150 T
JJS-200 T
JJS-200 T
JJS-40 T
JJS-50 T
JJS-70 T
JJS-80 T
JJS-90 T
JJS-100 T
JJS-150 T
JJS-200 T
JJS-200 T
JJS-80 T
JJS-100 T
JJS-125 T
PDM code: 00184674-G
Technical data