Warning Sticker; Cabinet Installed Units (Ip 00, Ul Type Open) - ABB ACS800 Hardware Manual

66
Wire size
kcmil/AWG
4
2
1
1/0
2/0
11. Tighten the clamping nuts of the cable glands.
After connecting the control cables, fasten the clear plastic shroud and front covers.

Warning sticker

There are warning stickers in different languages inside the packing box of the drive.
Attach a warning sticker in the language of your choice onto the plastic skeleton
above the power cable terminals.

Cabinet installed units (IP 00, UL type open)

The drive can be installed in a cabinet without the plastic front, top and connection
box covers and without the lead-through plate.
It is recommended:
• to ground the cable shield 360 degrees at the cabinet entry. Grounding with the
360 degrees grounding clamps at the connection box back plate is then not
needed.
• to lead the cable unstripped as close to the terminals as possible. Ground the
twisted shields of the power cables under the PE and grounding clamps.
Secure the cables mechanically.
Protect the RMIO board terminals X25 to X27 against contact when input voltage
exceeds 50 VAC.
Cover the power cable terminals with the clear plastic shroud as shown in section
Power cable installation procedure
Electrical installation
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Compression lug
Manufacturer Type
Burndy YA4C-L4BOX
Ilsco CCL-4-38
Burndy YA2C-L4BOX
Ilsco CRC-2
Ilsco CCL-2-38
Burndy YA1C-L4BOX
Ilsco CRA-1-38
Ilsco CCL-1-38
Thomas & Betts 54148
Burndy YA25-L4BOX
Ilsco CRB-0
Ilsco CCL-1/0-38
Thomas & Betts 54109
Burndy YAL26T38
Ilsco CRA-2/0
Ilsco CCL-2/0-38
Thomas & Betts 54110
Manufacturer
Burndy
Ilsco
Burndy
Ilsco
Ilsco
Burndy
Ilsco
Ilsco
Thomas & Betts
Burndy
Ilsco
Ilsco
Thomas & Betts
Burndy
Ilsco
Ilsco
Thomas & Betts
on page 62.
Crimping tool
Type No. of crimps
MY29-3 1
MT-25 1
MY29-3 2
IDT-12 1
MT-25 1
MY29-3 2
IDT-12 1
MT-25 1
TBM-8 3
MY29-3 2
IDT-12 1
MT-25 1
TBM-8 3
MY29-3 2
IDT-12 1
MT-25 1
TBM-8 3