Mounting The Drive On The Wall; Units Without Vibration Dampers; Units With Vibration Dampers; Cabinet Installation - ABB ACS800 Hardware Manual

36

Mounting the drive on the wall

Units without vibration dampers

1. Mark the locations for the four holes. The mounting points are shown in chapter
Dimensional
2. Fix the screws or bolts to the marked locations.
3. Position the drive onto the screws on the wall. Note: Lift the drive by its lifting
holes, not by its cover.
4. Tighten the screws in the wall securely.

Units with vibration dampers

In applications with considerable vibration in the frequency range of 50 Hz to
100 Hz, vibration dampers can be used. For units of frame size R5, see ACS800-01/
U1 Vibration Damper Installation Guide [3AFE68295351 (English)]. For units of
frame size R6, contact ABB for installation instructions.

Cabinet installation

The drive can be installed in a cabinet without the plastic front, top and connection
box covers and without the lead-through plate. Vibration dampers are not needed.
The required distance between parallel units is 50 millimetres (1.97 in.) in
installations without the front cover. The cooling air entering the unit must not exceed
+40°C (+104°F). Contact ABB, if two units are to be installed side by side at a
distance smaller than 50 millimetres (1.97 in.), i.e. the side air holes will be covered
at one side.
Mechanical installation
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
drawings.