Connecting A Ripple Control Receiver; Huawei Proprietary And Confidential - Huawei SmartLogger2000 User Manual

Hide thumbs Also See for SmartLogger2000:

Table of Contents

SmartLogger2000

User Manual

Verify that the brown cable (RS485A) of the PID module is connected to Surge port 1 or 7 on

the RS485 signal SPD, and that the black cable (RS485B) is connected to Surge port 5 or 11

on the RS485 signal SPD.

Step 3 Set Baud Rate for the PID module to the same Baud Rate configured for the SmartLogger.

----End

Follow-up Procedure

Take the reverse steps to disconnect the SmartLogger from the PID module.

4.9 Connecting a Ripple Control Receiver

Context

In Germany and some other European areas, a Ripple Control Receiver is used to convert a

power grid scheduling signal to a dry contact signal, in which a dry contact is needed.

Figure 4-30 shows the DI ports of the SmartLogger.

Figure 4-30 DI ports of the SmartLogger

Table 4-8 describes the DI ports.

(2016-06-20)

The baud rates supported by the PID module include 4800 bit/s, 9600 bit/s, 19200 bit/s, and 115200



bit/s.

The PID module supports automatic address allocation. After connecting cables, log in to the WebUI



and search for the PID module in the Connect Device > Auto. Search menu.

For details about PID parameter settings, see PID.



The default RS485 communications address of the PID module is 1. To change the RS485



communications address, log in to the WebUI and follow instructs in Connecting a Device.

4 Connecting Cables

Table of Contents