NEC UNIVERGE SV8300 System Maintenance Manual page 56

B
CM40 Specify the stop bit for the RS port.
NOTE:
Specify the DTR signal sent to terminal for the
RS port.
NOTE:
Specify the RTS signal sent to terminal for the
RS port.
NOTE:
Specify the data speed of the RS port.
NOTE:
END
(2) To confirm whether the call logs is collected in the CPU or to clear logs, do the following
programming.
START
CMEA Display the call logs
CPU or clear the logs.
END
DESCRIPTION
When using CPU RS-232C port for
PCPro, set the default.
When using CPU RS-232C port for
PCPro, set the default.
When using CPU RS-232C port for
PCPro, set the default.
When you communicate with CPU
built-in modem, be sure to set the
data speed of RS1 port as 4800 bps
or more (1200 bps and 2400 bps are
not available).
DESCRIPTION
that
are collected in the
Chapter 1 MAINTENANCE SERVICES
• Y=04
(1) 0: Unit01 Port1
1: Unit01 Port2
(2) 0 : 1-Stop bit
1 : 2-Stop bit
• Y=05
(1) 0: Unit01 Port1
1: Unit01 Port2
(2) 0 : Low
1 : High
• Y=06
(1) 0: Unit01 Port1
1: Unit01 Port2
(2) 0 : Low
1 : High
• Y=08
(1) 0: Unit01 Port1
1: Unit01 Port2
(2) 1
2
3
4
5
NONE : 9600 bps
• Y=6
(1) 01: Display of call log collection/log clear
(2) 0 : Logs are not collected
1 : Logs are collected
CCC: Log clear
1-44
VoIP LOG COLLECTION
DATA
: 1200 bps
: 2400 bps
: 4800 bps
: 9600 bps
: 19200 bps
DATA
NWA-033627-001 Rev.4.0
95ch1001.fm
JULY/17/2009