Ping Command - NEC UNIVERGE SV8300 System Maintenance Manual

PING COMMAND

[8300R2 software required]
General Description
By executing a ping command from the PCPro or the Customer Administration Terminal (CAT), you can
send a ping request to IP Station from the PBX. This enables you to confirm whether the IP terminal is
correctly connected/set or not.
Service Conditions
(1) By executing a ping command (CMFA Y=2001 [01: Unit No.]), only one ping request is sent from
the PBX to the terminal connected to the PBX with a LAN. And you confirm whether a reply to the
ping request is received from the terminal or not.
NOTE:
You can send a ping request only once by executing a ping command once. So you can not set
the ping request parameter such as number of times that the ping request is sent by executing a
ping command.
(2) The LAN interface (Maintenance Port and VOIP Port) is automatically selected if the IP address of
the destination for the ping command assigned.
(3) The time limit for replying to a ping request in this feature is fixed to about 2-4 seconds. If the time
limit is exceeded, "REQUEST TIMEOUT" is displayed.
PBX
IP Station
Chapter 1 MAINTENANCE SERVICES
1 Executing a ping command
(CMFA Y=2001)
2
Display of a ping request
transmission result
1-52
PING COMMAND
PCPro (PC)
LAN
NWA-033627-001 Rev.4.0
95ch1001.fm
JULY/17/2009