NEC UNIVERGE SV8300 System Maintenance Manual page 82

FAULT
KIND NUMBER
104 SV8300 Blade down
106 SV8300 Blade reset with CME03
107 Lack of option value
108 Lack of Highway Channel
109 Auto Blade Reset by TDM-Blade Lockup
[8300R3 software required]
10A CPU SRAM failure
[8300R3 software required]
10B Restricted blade
[8300R3 software required]
10C Firmware version un-matching between CPU blade and Line/Trunk blade
[8300R3 software required
10D Lack of Highway Channel for data communication
[8300R3 software required]
10E Illegal use of CPU blade for Remote Unit only
[8300R3 software required]
110 Communication error occurrence between active CPU and stand by CPU
[8300R4 software required]
112 Expansion Chassis (2U) failure
[8300R3 software required]
114 Automatic module reset due to Expansion Chassis (2U) lockup
[8300R3 software required]
115 Automatic system reset due to Expansion Chassis (2U) lockup
[8300R3 software required]
116 All blades lockup in Expansion Chassis (2U)
[8300R3 software required]
Chapter 2 TROUBLESHOOTING
FAULT CONTENT
2-14
FAULT INFORMATION DISPLAY
NWA-033627-001 Rev.4.0
95ch2001.fm
APRIL/16/2010