Service
Manual
Before any intervention it is essential to cut off all supply of the machine
Repair
Replacement of the E1/E2 electrode:
1. Remove the left side frame of the machine.
2. Stop and remove the customer gas supply.
3. Remove the tap stop lever.
4. Disconnect the wire of the electrovalve.
5. Unscrew the 4 screw which fi x the gas pipe burner on the end fl ange.
6. Remove the right side frame of the machine.
7. Remove the hoses.
8. Remove the fender waling.
9. Remove the gas pipe burner of the guide (right side).
10. Get out the gas pipe burner by the left side until the electrode is accessible.
11. Disconnect the wire of the faulty electrode.
12. Remove the faulty electrode and replace it by a new one.
13. Adjust the electrode at 2mm compared to the ceramic plates like below.
14. Connect the new electrode.
15. Put back the parts in the inverse order of disassembling.
04102011/GB
50.2011
Gas heating
(electricity, steam, water, gas, compressed air...).
ceramic plate
gas pipe burner
electrode
25
11