Replacement Of The Dp3, Dp4, Dp5 And Dp22 Inductive Detectors; Replacement Of The Dp1 Inductive Detector - Electrolux IC4 4819 FFS Service Manual

Service
Manual
Before any intervention it is essential to cut off all supply of the machine
Repair

Replacement of the DP3, DP4, DP5 and DP22 inductive detectors:

The indicator of the detector must lit when we put a metal part on the detector. If it is not the
case, the detector is faulty.
Remove / Assembly:
1. Remove the left side frame of the machine.
2. Disconnect the wire of the faulty detector.
3. Remove the detector and replace it by a new one.
4. Connect the wire on the new detector.
5. Adjust the detector at a distance from 2 or 3 mm compared to the part
to detect (the indicator of the detector lights).
6. Put back the frame.

Replacement of the DP1 inductive detector:

The indicator of the detector must fl ashed when the ironing cylinder is in motion. If it is not the
case, the detector is faulty.
Remove / Assembly:
1. Remove the left side frame of the machine.
2. Disconnect the wire of the faulty detector.
3. Remove the detector and replace it by a new one.
4. Connect the wire on the new detector.
5. Adjust the new detector at a distance from 2 or 3 mm compared to the part to detect
(the indicator of the detector lights).
6. Put back the frame.
04102011/GB
19.2013
Longitudinal folding: PLIVIT
(electricity, steam, water, gas, compressed air...).
32
13