Replacement Of The Dp73 Sensor - Electrolux IC4 4819 FFS Service Manual

Service
Manual
Before any intervention it is essential to cut off all supply of the machine
Repair

Replacement of the DP73 sensor:

Under voltage, the sensor must worked as follow:
If the above conditions are not validated, the sensor is faulty.
Remove / Assembly:
1. Disconnect the wire of the faulty sensor.
2. Remove the sensor and replace it by a new one.
3. Connect the wire of the new sensor.
4. Switch on the machine and check the operation of the sensor.
Setting to before to put the sensor on the machine:
1. Put a object at 30 mm in front of the sensor.
2. Adjust the A button of the sensor in order to detect this object (green + red indicator).
04102011/GB
21-2012
Feeding: Smoothing system
(electricity, steam, water, gas, compressed air...).
- no detection = green indicator
- detection = green + red indicator
29
9