Example:
Programming
CPMSTART[X2]="ON"
Constraints
•
The coupling characteristics set with CPMSTART are retained until the coupling module is
deleted with (CPDEL).
•
For the set coupling type (CPSETTYPE="TRAIL", "LEAD", "EG" or "COUP"), the
response is defined by the following machine data during part program start:
MD20112 $MC_START_MODE_MASK (Definition of the control default settings in case of
NC START)
→ See Section "Defaults" in " Coupling types (CPSETTYPE) [Page 317] ".
5.5.5.13 Status during part program start in search run via program test (CPMPRT)
At part program start during search run via program test (SERUPRO), the coupling can be
activated, deactivated or the current status can be retained. The behavior can be set
separately for each coupling module.
Programming
Syntax:
Identifiers:
Functionality:
Special Functions
Function Manual, 09/2011, 6FC5397-2BP40-2BA0
Comment
; At part program start, coupling to following axis X2 is
switched on.
CPMPRT[FAx]= <value>
Coupling Mode Program Test
Defines the behavior of a coupling at part program start during search
run via program test.
M3: Coupled axes
5.5 Generic coupling
301