Siemens SIMATIC S5 Manual page 330

PLC Error Messages
Error Con-
Error Message Text
Identi- sec.
fier No.
Progr.
109 09
FB call with wrong
parameter: Programming
error
109 10
Block stack overflow,
Nesting depth > 16:
Programming error
109 11
Undefined STEP 5 operation
(NNN): Programming error
109 12
STS operation in user
program: Desired PLC stop
109 13
Transfer error (TRAF),
Parameter > number of DB
words: Programming error
B-70
Possible Cause
Error group No. 12
Substitution error (SUF) during FB
call in user program
Error group No. 12
- Maximum block call nesting in
user program exceeded
Error group No. 26
- Uncoded operation
- Nesting levels exceeded
- Parameters exceeded
Error group No. 26
- SW stop by statement
- SW request from PG or SINEC L1
master
Error group No. 12
Transfer error:
- Programmed DB operation:
* DW No. > DB length
* DB opening forgotten
S5-115F Manual
Remedy
- Correct function block call
(analyze ISTACK)
Warm restart:
1. Stop/Run
- Remove programming error
(BSTACK, ISTACK)
Warm restart:
1. Stop/Run
- Remove programming error
(BSTACK, ISTACK)
Warm restart:
1. Stop/Run
Warm restart:
1. Stop/Run
- Remove programming error
Warm restart:
1. Stop/Run
EWA 4NEB 811 6149-02