Siemens SIMATIC S5 Manual page 40

S5-115F Manual
Transferring the configuration data
You can transfer the data stored in the programmer with the transfer functions to any of the
following:
• Diskette drive or hard disk drive
• PLC memory
• EPROM/EEPROM submodule
Transferring the control program and the configuration data to EPROM/EEPROM submodules
If you want to store the control program and the configuration data on EPROM/EEPROM
submodules, you always require two identical memory submodules. Before you transfer your
control program and the configuration data to the EPROM/EEPROM submodule, you must load
this data into the programmer memory.
After you have transferred
EPROM/EEPROMs, you must sign the EPROM/EEPROM submodules and enter the subunit ID. For
this purpose, press F7 "EPR. SIG". The COM 115F software will prompt you for the subunit ID of the
EPROM/EEPROM submodule and sign the EPROM/EEPROM submodule automatically.
Note
Please note that the order of blocks in the both EPROM/EEPROM submodules for
subunit A and B must be identical so that the signatures are identical.
The COM 115F programming software requires 26 bytes of free memory in the me-
mory submodule for entering the signature and other internal data.
After entering the signature you cannot transfer any further blocks to the
EPROM/EEPROM submodule.
F4 Print
Press the F4 key to call the Print menu ( Figure 1-18). You can print out your configuration
DBs in plaintext using this menu. If the configuration DBs for PLC, FD or EPROM/EEPROM are
to be printed out, they must first be loaded into the user RAM.
Print
F1 DI
F2 DQ
F3 AI
F4 AQ
F5 all C DBs
F6 I/O types
F7 DB 1
F8 RETURN
F1
DI
EWA 4NEB 811 6149-02
your user
PROGRAM FILE: A:@@@@@@ST.S5D
: Print digital inputs
: Print digital outputs
: Print analog inputs
: Print analog outputs
: Print all configuration DBs
: Print I/O types
: Print DB 1
: Return to previous menu
F2 F3 F4
DQ AI AQ
Figure 1-18. Menu for Printouts
program and the
COM 115F / PDC15
F5 F6
ALL C DBs I/O TYPES
Configuring with COM 115F
configuration DB to
F7 F8
DB 1 RETURN
both
1-27