Installation And Commissioning Flowchart - ABB ACS800-U7 Hardware Manual

Installation and commissioning flowchart

Identify the frame size of your drive: R6, R7 or R8.
Plan the installation.
Check the ambient conditions, ratings, required
cooling air flow, input power connection, compatibility
of the motor, motor connection, and other technical
data.
Select the cables.
Unpack and check the units.
Check that all necessary optional modules and
equipment are present and correct.
Only intact units may be started up.
Check the installation site.
If the drive is about to be connected to an IT
(ungrounded) system, check that the drive is not
equipped with EMC filter +E202.
Route the cables.
Check the insulation of the motor and the motor
cable.
Install the drive. Connect the power cables. Connect
the control and the auxiliary control cables.
Check the installation.
Commission the drive.
Commission the optional brake chopper (if present).
Task See
Technical data / IEC data
Technical data
Planning the electrical installation
Option manual (if optional equipment is
included)
Mechanical installation: Moving the
installation
If the converter has been non-operational for
more than one year, the converter DC link
capacitors need to be reformed. Ask ABB for
instructions.
Mechanical installation: Before installation
Technical data
Operation principle and hardware
Type designation key. For instructions on how
to disconnect the EMC filtering, contact ABB.
Planning the electrical installation:
cables
Electrical installation: Checking the insulation of
the assembly
Mechanical installation, Electrical installation,
Resistor braking (optional)
Installation checklist and start-up
Installation checklist and
firmware manual
Resistor braking
Introduction to the manual
19
or NEMA data
unit, Before
description:
Routing the
start-up, appropriate