Commissioning; Operation On Addressed Detector Line (Fdnet/C-Net) - Siemens FDA241 Technical Manual

7 Commissioning

7.1
Building Technologies
Fire Safety
The aspirating smoke detector is supplied with factory settings and can be
operated with these settings. If it is used on an addressed detector line, some basic
settings (date, time, sensitivity, etc.) can be made from the control panel. However,
to make all the settings you will need the 'FXS2051 ASD Configuration Tool'
software.
Operation on addressed detector line
(FDnet/C-NET)
Proceed as described in Standalone application [➙ 82] and then start the detector
line.
 The external power unit is connected to the aspirating smoke detector.
1. Switch the power supply on.
2. Check whether the aspirating smoke detector is being supplied with power. The
LED lights up.
3. Start the detector line.
 The aspirating smoke detector is not detected as FDA241 or FDA221 by the
fire control panel.
If the aspirating smoke detector has not been detected correctly, refer to the fire
control panel documentation for the remainder of the process.
The following document applies to fire control panels FC20xx: 009052, chapter
'Modifying and extending the detector line'.
The following document applies to fire control panels FC72x: A6V10210416,
chapter 'Modifying and extending the detector line'.
1. After completing step 1 as described in the document, switch off the power
supply for the aspirating smoke detector.
2. Wait one minute; then switch the aspirating smoke detector power supply back
on.
⇨ The aspiration unit starts up.
3. Now proceed as described in the documentation for the fire control panel.
If the aspirating smoke detector has already been registered on the detector line,
refer to the fire control panel documentation for the remainder of the process.
The following document applies to fire control panels FC20xx: 009052, chapter
'Removing or replacing non-stationary FDnet devices'.
The following document applies to fire control panels FC72x: A6V10210416,
chapter 'Removing or replacing non-stationary C-NET devices'.
The following settings can be made directly from the control panel to change the
basic settings:
Setting the 'Manned' or 'Unmanned' parameter set

Setting the 'Purge' activation mode

Setting the 'Air'

Setting the Detector mode

Setting the Test mode

These settings cannot be changed with the 'FXS2051 ASD Configuration Tool'
software, only read.
Commissioning
Operation on addressed detector line
A6V10334410_h_en_--
7
79
2015-09-29