Simultaneous Recording Before Machining Of The Workpiece - Siemens SINUMERIK 840D sl Operating Manual

Machining the workpiece
3.10 Simulating a machining operation
3.10.3

Simultaneous recording before machining of the workpiece

Before machining the workpiece on the machine, you can graphically display the execution
of the program on the screen to monitor the result of the programming.
You can replace the programmed feedrate with a dry run feedrate to influence the speed of
execution.
If you would like to view the current program blocks again instead of the graphical display,
you can switch to the program view.
118
4. Press the "Simulation" and "Start" softkeys.
The program execution is displayed graphically on the screen. The
machine axes do not move.
5. Press the "Stop" softkey if you wish to stop the simulation.
- OR -
Press the "Reset" softkey to cancel the simulation.
The unmachined workpiece blank is displayed again.
6. Press the "Start" softkey to restart the simulation.
Software option
You require the option "3D simulation of the finished part" for the 3D
view and the 4-window view.
Software option
You require the option "Simultaneous recording (real-time simulation)" for
the simultaneous recording.
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
HMI sl Turning