2.7.7
Measuring the workpiece zero
Procedure
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
4.
Press the "Details" softkey.
5.
Position the cursor on the zero offset you would like to delete.
6.
Press the "Clear Offset" soft key.
1.
Select the "Parameter" operating area and press the "Work offset"
softkey.
2.
Press the "G54...G599" softkey and select the work offset in which the
zero point is to be saved.
3.
Press the "Workpiece zero" softkey.
You change to the "Set Edge" window in the "JOG" mode.
4.
Traverse the tool in the Z direction and scratch it.
5.
Enter the position setpoint of the workpiece edge Z0 and press the
"Set WO" softkey.
Setting up the machine
2.7 Work offsets
67