Simulating The Program Block By Block - Siemens SINUMERIK 840D sl Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
3.10.8.2
Simulating the program block by block
You can control the program execution during simulation, i.e. execute a program block by
block, as when executing a program.
Procedure
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
1.
Simulation is started.
2.
Press the "Program control" and "Single block" softkeys.
3.
Press the "<<" and "Start SBL" softkeys.
The pending block of the program is simulated and then stops.
4.
Press "Start SBL" as many times as you want to simulate a single
program block.
5.
Press the "Program control" and the "Single block" softkeys to exist the
single block mode.
Machining the workpiece
3.10 Simulating a machining operation
125
Advertisement
Table of Contents
