Defining An Interruption Point As Search Target - Siemens SINUMERIK 840D sl Operating Manual

Machining the workpiece
3.6 Starting machining at a specific point
3.6.4

Defining an interruption point as search target

Requirement
A program was selected in "AUTO" mode and interrupted during execution through "CYCLE
STOP" or "RESET".
Procedure
98
1. Press the "Block search" softkey.
2. Press the "Interrupt point" softkey.
The interruption point is loaded.
3. If the "Higher level" and "Lower level" softkeys are available, use
these to change the program level.
4. Press the "Start search" softkey.
The search starts. Your specified search mode will be taken into
account.
The search screen closes.
The current block will be displayed in the "Program" window as soon
as the target is found.
5. Press the "CYCLE START" key twice.
The execution will continue from the interruption point.
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
HMI sl Turning