Tool Management; Lists For The Tool Management; Magazine Management - Siemens SINUMERIK 840D sl Operating Manual

Tool management

7.1

Lists for the tool management

All tools and also all magazine locations that have been created or configured in the NC are
displayed in the lists in the Tool area.
All lists display the same tools in the same order. When switching between the lists, the
cursor remains on the same tool in the same screen segment.
The lists have different parameters and softkey assignments. Switching between lists is a
specific change from one topic to the next.
● Tool list
● Tool wear
● Magazine
● Tool data OEM
Sorting the lists
You can change the sorting within the lists:
● According to magazine
● According to tool identifier (alphabetic)
● According to tool type
● According to T number (numeric tool identifier)
7.2

Magazine management

Depending on the configuration, the tool lists support a magazine management.
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
All parameters and functions required to create and set up tools are displayed.
All parameters and functions that are required during operation, e.g. wear and monitoring
functions, are listed here.
Magazine and magazine location-related parameters and functions for the tools and
magazine locations are listed here.
This list can be freely defined by the OEM.
7
287