Siemens SINUMERIK 840D sl Operating Manual page 21

(3)
(4)
(5)
(6)
(7)
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
RESET
Stop processing the current programs.
•
The NCK control remains synchronized with the machine. It is in its
initial state and ready for a new program run.
Cancel alarm.
•
Program control
SINGLE BLOCK
Single block mode on/off.
CYCLE START
The key is also referred to as NC Start.
Execution of a program is started.
CYCLE STOP
The key is also referred to as NC Stop.
Execution of a program is stopped.
Operating modes, machine functions
JOG
Select "JOG" mode.
TEACH IN
Select "Teach In" submode.
MDA
Select "MDA" mode.
AUTO
Select "AUTO" mode.
REPOS
Repositions, re-approaches the contour.
REF POINT
Approach reference point.
Inc VAR (incremental feed variable)
Incremental mode with variable increment size.
Inc (incremental feed)
Incremental mode with predefined increment size of 1, ..., 10000
...
increments.
Customer keys
T1 to T15
Traversal axes with rapid traverse superposition and coordinate exchange
Axis keys
Selects an axis.
...
Machine manufacturer
A machine data code defines how the increment value is
interpreted.
Introduction
1.3 Machine control panels
21