4.7.4
Defining an interruption point as search target
Prerequisite
A program was selected in "AUTO" mode and interrupted during execution through CYCLE
STOP or RESET.
Procedure
4.7.5
Entering the search target via search pointer
Enter the program point which you would like to proceed to in the "Search Pointer" window.
Requirement
The program is selected and the controller is in Reset mode.
Screen form
Each line represents one program level. The actual number of levels in the program depends
on the nesting depth of the program.
Level 1 always corresponds to the main program and all other levels correspond to
subprograms.
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
1.
Press the "Block search" softkey.
2.
Press the "Interrupt point" softkey.
The interruption point is loaded.
3.
If the "Higher level" and "Lower level" softkeys are available, use
these to change the program level.
4.
Press the "Start search" softkey.
The search starts. Your specified search mode will be taken into
account.
The search screen closes.
The current block will be displayed in the "Program" window as soon
as the target is found.
5.
Press the <CYCLE START> key twice.
The execution will continue from the interruption point.
Machining the workpiece
4.7 Starting machining at a specific point
133